Building inspectors or flooring contractors use moisture metres to determine ideal conditions when installing floor tiles over a concrete slab or subfloor. Tramex concrete moisture metre employs advanced analogue and digital technology to greatly extend the capability of the instrument.
Features:
- Tramex concrete moisture metre CME 4 comes with two simple push-button controls - ON/OFF and HOLD.
- It automatically powers OFF after 10 minutes of inactivity to conserve battery life. NOTE: If the metre reading changes or a button is pressed, the power remains ON.
- This unit features two LED indicators. Upon pressing the ON/OFF button, the lower LED illuminates and remains illuminated until the CME 4 automatically shuts off. A flash appears on the upper LED when HOLD is selected.
- Concrete moisture readings ranging from 0% to 6% are displayed on a clear & easy to read moving coil metre with a linear scale.
- To facilitate the easy recording of readings, the HOLD button freezes the needle on the moving coil metre.
Frequently Asked Questions:
Q. What levels of moisture are acceptable?
A. It is acceptable to have moisture readings up to 17%. Readings over 17% indicate saturation, which means that the drywall needs to be replaced and measurements should be taken to prevent moisture build-up in the future.
Q. How do you read a Tramex concrete moisture metre?
A. In order to test a wooden sample, turn on the device, select Scale 1 and press the rubber electrodes directly to the wooden surface. In the top line of the analogue dial (where calibration is marked from 5% to 30%), read the moisture percentage. Upon activation, the audio signal will be played when readings are above 18%.
