LOVEJOY 84527105149 Horizontal Mounting Bracket, Hydraulic Pump

Features:

• This mounting bracket has an aluminium alloy body to resist corrosion on exposed surfaces.
• It features a weep hole to drain pump leakages.
• This bracket can be mounted with NEMA C-Face motors in frame sizes 56C to 405TSC for 2 & 4-bolt pump flanges.
• It is equipped with a motor / pump mounting kit, bolts and washers to mount the pump / motor.

Standards and Approvals:

• SAE

Frequently Asked Questions:

Q. What is the bolt-hole diameter of this bracket?

A. 17/32 inches.

Q. How do I clean and maintain Lovejoy 84527105149 horizontal mounting bracket?

A.

• Disconnect any power source connected to the bracket and allow it to cool down if it has been in use.
• Use a soft, dry cloth to wipe down the surface of the bracket, removing any dust or debris.
• To remove stubborn dirt or grime, dampen a clean cloth with water and wipe it down the surface of the bracket.
• Do not use any harsh chemicals or abrasives as this may damage the surface.
• Check for any signs of wear or damage, cracks or corrosion. If any damage is found, the bracket should be replaced.
• Lubricate any moving parts of the bracket using a silicone-based lubricant or equivalent, ensuring smooth operation and preventing wear and tear.
• Reconnect any power source and test the bracket to ensure it is functioning properly.
• Regularly check the bracket for signs of wear or damage and clean & lubricate it as needed to ensure optimal performance and longevity.

Q. How to install this mounting bracket?

A.

• Remove any dirt or debris from the surface and ensure that it is level.
• Position the bracket on the mounting surface in the desired location.
• Mark the location of the mounting holes on the surface using a marker or pencil.
• Using an appropriate drill bit, drill the holes in the mounting surface at the marked locations.
• Place the bracket onto the mounting surface and align the mounting holes on the bracket with the holes on the mounting surface.
• Insert appropriate screws or bolts through the mounting holes and tighten them with a wrench or socket driver.
• Secure the hydraulic pump to the bracket using appropriate fasteners or clamps.
• Verify that the hydraulic pump is securely mounted and properly aligned with the bracket.
• Double-check that all screws or bolts are tightened to the recommended torque specifications.