Item | Centrifugal Pump |
Agency Compliance | CUS |
Amps | 10 |
Bearing Type | Ball |
Best Efficiency GPM @ Head | 90 @ 48 Ft. |
Best Efficiency Range GPM @ Head | 110-40 @ 28-65 Ft. |
Drain Plug | No |
Duty | Continuous |
GPM of Water @ 10 Ft. of Head | 144 |
GPM of Water @ 15 Ft. of Head | 138 |
GPM of Water @ 20 Ft. of Head | 131 |
GPM of Water @ 25 Ft. of Head | 126 |
GPM of Water @ 30 Ft. of Head | 116 |
GPM of Water @ 40 Ft. of Head | 105 |
GPM of Water @ 5 Ft. of Head | 150 |
GPM of Water @ 50 Ft. of Head | 85 |
GPM of Water @ 60 Ft. of Head | 62 |
GPM of Water @ 70 Ft. of Head | 38 |
GPM of Water @ 80 Ft. of Head | 5 |
Height | 7.75" |
Housing Material | 316 Stainless Steel |
HP | 3 |
Hz | 60 |
Impeller Material | Stainless Steel |
Impeller Type | Closed |
Inlet | 2" NPT |
Inlet Pressure | 115 PSI |
Inlet Type | 2" NPT |
Length | 15.375" |
Max. Case Pressure | 150 PSI |
Max. Dia. Solids | 1/8" |
Max. Fluid Viscosity | 260 SSU |
Max. GPM @ Head | 150 @ 5 Ft. |
Max. Head | 81 ft. |
Max. Liquid Temp. | 300 F |
Max. Specific Gravity | 1 |
Min. GPM @ Head | 38 @ 70 Ft. |
Motor Enclosure | TEFC |
Motor RPM | 3450 |
Motor Type | Capacitor-Start, Capacitor-Run |
NEMA/IEC Frame | 56J |
Outlet | 1-1/2 NPT |
Phase | 1 |
Port Rotation | 90 Degrees Increments |
Screw Material | Stainless Steel |
Seal Material | Viton, Carbon/Ceramic |
Seal Type | Mechanical |
Service Factor | 1.15 |
Shaft Material | Stainless Steel |
Type | Chemical Resistant |
Voltage | 230 |
Wetted Materials | 316 Stainless Steel, Viton, Carbon, Ceramic |
Width | 10.5" |